Viconics VWG-50 (Classic ZigBee) Installation Guide Manual de usuario

1 | VWG-50-Installation Manual CONTENTS Disclaimers 2Trademarks 3Overview 3Parts Available 4Preparation 4Included in this Package 4

10 | VWG-50-Installation Manual Board Layout Figure below shows the location of LEDs, connections and other features of the VWG with the cover rem

11 | VWG-50-Installation Manual VWG-PS-AC 120 VAC WALL MOUNTED POWER SUPPLY Both the U.S. and International models of wall power modules are self-con

12 | VWG-50-Installation Manual The packing slip accompanying the VWG will provide the “factory-shipped” IP settings for both NET1 and NET2. Refer to

13 | VWG-50-Installation Manual RS485-BACnet™ MS-TP wiring. An RS485, optically isolated port uses a 3-position, screw terminal connector and alwa

14 | VWG-50-Installation Manual ANTENNA INSTALLATION Controller mounted antenna (VWG-WA) All VWG-50 are supplied with a controller-mounted antenna.

15 | VWG-50-Installation Manual 2) Apply Power Apply power to the VWG by plugging in the power plug into either the VWG (if wall mount AC adapter VWG

16 | VWG-50-Installation Manual RELATED DOCUMENTATION For more information on configuring and using the VWG controller, consult the following docume

17 | VWG-50-Installation Manual 1 x 200ms short blink Power on 2 x 200ms short blinks Power on and card memory initialized properly 3 x 200ms short b

18 | VWG-50-Installation Manual Table 4 Standard replacement parts. Part Number Description VWG-BB NiMH Battery Pack (with battery bracket)—see “Rep

19 | VWG-50-Installation Manual CERTIFICATIONS Federal Communications Commission (FCC) This equipment generates, uses, and radiates radio frequency

2 | VWG-50-Installation Manual DISCLAIMERS NO WARRANTY. Viconics, Inc. (herein after referred to as “Viconics”) makes no warranty as to the accuracy

20 | VWG-50-Installation Manual Chassis • Construction: Plastic, din rail or screw mount chassis, plastic cover • Cooling: Internal air convection •

3 | VWG-50-Installation Manual Ferrites supplied with the power supply and VWG MUST be installed according to instructions. Failure to do so may void

4 | VWG-50-Installation Manual PARTS AVAILABLE Part number Description VWG-50-5000 Viconics BACnet™™ over MS-TP & IP wireless gateway. Include

5 | VWG-50-Installation Manual Material and Tools Required The following tools and supplies may be required for installation:  DIN rail, type NS35

6 | VWG-50-Installation Manual Static Discharge Precautions Static charges produce voltages high enough to damage electronic components. The micropro

7 | VWG-50-Installation Manual MOUNTING Mount the VWG in a location that allows clearance for wiring, servicing, and antenna removal. Environmental

8 | VWG-50-Installation Manual Procedure 1 - To mount on DIN rail Step 1 Securely install the DIN rail using at least two screws, near both end

9 | VWG-50-Installation Manual Installation Minimum Spacing Distance Requirements Make sure minimum spacing distance requirements is available to fr